Bedford CF-UK Message Board Logo [Home] [Search] [FAQ]
Bedford CF-UK Message Board > CF Questions > propshaft trouble
[Private Message] [Register] [Profile] [Member list] [Log-in]
Who's Online:
There are 0 member(s), and 1 guest(s) online.
 
[Printable Version] [Post Reply]
Author Message
Anon
Deleted
Posts :
Location :
Status    : Offline

propshaft trouble

Hi guys I have stumbled across a problem whilst trying to fit a Vauxhall carlton 2.0 engine and box (c20ne) into my cf 250 .
I was told I could attach the front part of Carlton prop to the Bedford one but in order to do that i am going to lose one of the uj's. Will this be an issue?
Also the Bedford prop is on a spline into the gearbox which allows movement whereas the Carlton one is not, is this going to be a problem?
Any ideas would be much appreciated
Cheers, Luke

----------------------

Tue 21 Jan 2014 @ 11:08 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

propshaft

weld the sliding shaft to the carlton prop after removing the front flange
Sat 22 Feb 2014 @ 23:31 Edit this messageQuote this messagePMQuote this message
Gethin
Card Holder
Posts : 462
Location : east lancs
Status    : Offline

you need that uj next to the gearbox or you will rip both gearbox and prop to bits.

you need a way of using the carlton front part grafted to the beddy prop
Sun 23 Feb 2014 @ 21:52 View Gethin   Email Gethin   Edit this messageQuote this messagePMQuote this message
Time in GMT
[Post Reply]
New posts since your last visit Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c